The 3k-access(config)# authentication mac-move permit command can be used to allow a host to disconnect from an IP phone that is not manufactured by Cisco and authenticate on a different port on the same switch. common authentication mac-move permit The Device discovery configuration enables probes that the ISE profiler will use for profiling device types.
Authentication mac move permit Pc#
The 3k-access(config)# authentication mac-move permit command can be used to allow a new host to authenticate to an IP phone that is not manufactured by Cisco Cisco IP phones use Cisco Discovery Protocol to signal to the Cisco Catalyst switch that the tethered PC has disconnected. The 3k-access(config-if)# authentication violation replace command can be used to allow a host to disconnect from an IP phone that is not manufactured by Cisco and authenticate on a different port on the same switch. The 3k-access(config-if)# authentication violation replace command can be used to allow a new host to authenticate to an IP phone that is not manufactured by Cisco. Cisco IP phones send a RADIUS packet with Cisco-av-pair UCPort= Disco to signal to the Cisco Catalyst switch that the tethered PC has disconnected.
2) copy run start 3) relad 4) Do a 'sh run i. 1) enter 'no authentication mac-move permit' comand in global configuration mode.
But,this configuration is appear though the you set the 'no authentication mac-move permit' after system relad. Select 802.1X for port-based authentication or select 802.1X-MAC-. Symptom: mac-move global configuration CLI : authentication mac-move permit ' is enabled by default. Which three statements about hosts moving from port to port on the same switch that is configured for 802.1X are true? (Choose three.) Using the GUI: Go to Switch > Interface > Physical.
0 kommentar(er)
